As a mud tank and solids control system manufacturer, with location in China, DC designed mud tanks for over 20 countries in the world. DC oil drilling solids control system is consisted of a group of mud tanks and solids control equipment.

The mud tank is to store the drilling mud for circulation, and the solids control equipment is for cleaning the drilling solids, mixing drilling mud, or agitating the drilling mud. The mud tanks design including the construction of the mud tanks, selection of the solids control equipment, layout of the pipelines etc.

solid control system

Mud tank types in the Solids Control system:

No. 1 Mud tank is normally the Shale Shaker tank ( Sometimes there is an extra small tank which called trip tank will the No. 1 tank)
No. 2 Mud tank is the active mud tank.
No. 3 Normally is the mud suction tank for the suction of mud pumps.
No. 4 Mud tank is the mud mixing tank

Selection of Solids Control Equipment for the mud tank.

The selection of the solids control equipment for the mud tank is also depends on the drilling rig size and drilling conditions. List of the main solids control equipment for the drilling rigs are as below:
1) One Each ZYQ1000 Mud gas Separators
2) Three Each of DCS700-3 Linear Motion shale shakers for 1500 GPM handling capacity
3) One each of DCZCQ270A vacuum degasser
4) One each of DCQJ250X3/100X16 mud cleaner which including 3 ten inch desander, 16 four inch desilter for the capacity up to 1500 GPM.
5) Two 75HP DCSB8x6 centrifugal pumps for feeding the mud cleaner, and two 75 HP mixing pumps for the mixing hoppers.
6) One middle speed DCLW450 decanter centrifuges for barite recovery or high gravity solids separation.
7) One high speed DCLW363BG decanter centrifuge for low gravity fine solids separation.

Besides the solids control equipment, the mud tank should also have the mixing and agitation device. On the low pressure mud rolling lines a sufficient number of bottom DCNJQ series mud guns complete with nipples, pipes, butterfly valves, hammer unions and a handle to rotate the mud gun from mud tank surface etc

in addition to this, DC Solid control can design a complete mud circulation system acoording to uers request, and provide you the 3D flow draw for your confirmation. So if you have interest with it please contact us by email adela@dcmudcleaningequipment.com

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>

Post Navigation